Calcium Oxide-Based Hybrid Nanomaterials for Corrosion Protection: A Critical Review of Structure–Electrochemical Performance Relationships, Interfacial Mechanisms and Data-Driven Design

Kufre E. Essien *

Department of Chemistry, Research Unit, Akwa Ibom State University, P.M.B. 1167, Akwa Ibom, Nigeria.

Okon E. Okon

Department of Chemical Sciences, Akwa Ibom State Polytechnic, Akwa Ibom, Nigeria.

Ekemini J. Obosi

Department of Chemical Sciences, Akwa Ibom State Polytechnic, Akwa Ibom, Nigeria.

Idaraesit A. Ite

Department of Chemistry, Research Unit, Akwa Ibom State University, P.M.B. 1167, Akwa Ibom, Nigeria.

*Author to whom correspondence should be addressed.


Abstract

Calcium oxide and the calcium phases derived from it have attracted attention as low-cost, low-toxicity and frequently waste-derived constituents of corrosion-protective materials, at a time when chromate-based technologies are being withdrawn and nanostructured coatings are expected to provide both barrier and active protection. The literature that describes calcium oxide-based hybrid nanomaterials is, however, dispersed across organic coatings, inorganic pigments, stimuli-responsive containers, layered double hydroxides, magnesium alloy design, plasma electrolytic oxidation and sol–gel layers, and it has rarely been examined as a single body of evidence. This critical narrative review synthesises peer-reviewed literature identified through structured searching of multidisciplinary and open scholarly indexes, supplemented by citation tracking and retraction checking, with eligibility determined by first public journal publication up to September 2026. The synthesis indicates that calcium oxide is better regarded as a reactive precursor than as a stable protective phase, because hydration and carbonation transform it into calcium hydroxide, amorphous and crystalline calcium carbonates or mixed carbonates under most service conditions. Protective effects attributed to calcium oxide are therefore mediated mainly by interfacial alkalinisation, calcium-driven precipitation at cathodic sites, ion exchange, pH-triggered container dissolution and, in magnesium, In situ formation of magnesium oxide and calcium-bearing intermetallic phases. The evidence is strongest for calcium carbonate containers, calcium-exchanged silica pigments, calcium–aluminium layered double hydroxides and dilute calcium oxide additions to magnesium alloys, and weakest for calcium oxide nanoparticles used as dissolved inhibitors in acidic media, where neutralisation, short exposures and doubtful adsorption analyses confound interpretation. Structure–performance relationships are non-monotonic: optimum loadings exist, excess calcium promotes micro-galvanic attack in magnesium, and alkalinity can accelerate cathodic delamination. Data-driven design remains largely confined to organic inhibitors and generic coatings, and no curated, phase-resolved dataset for calcium-based hybrids exists. Progress will require post-exposure phase identification, standardised long-duration electrochemical protocols, reporting of negative results and machine-learning workflows grounded in physically meaningful descriptors. Calcium oxide-based hybrids are a credible but still immature design space whose promise depends on controlling, rather than ignoring, calcium phase evolution.

Keywords: Calcium carbonate microcontainers, calcium-exchanged silica, layered double hydroxides, magnesium alloys, interfacial alkalinisation, electrochemical impedance spectroscopy, machine learning, smart anticorrosion coatings


How to Cite

Essien, Kufre E., Okon E. Okon, Ekemini J. Obosi, and Idaraesit A. Ite. 2026. “Calcium Oxide-Based Hybrid Nanomaterials for Corrosion Protection: A Critical Review of Structure–Electrochemical Performance Relationships, Interfacial Mechanisms and Data-Driven Design”. Asian Journal of Applied Chemistry Research 17 (4):200-224. https://doi.org/10.9734/ajacr/2026/v17i4439.

Downloads

Download data is not yet available.